O-rings
An O-ring is defined by its inside diameter and its cross-section. A used ring is often stretched, flattened or swollen, so measure a new ring where possible. Otherwise, the groove and the parts it seals give more reliable dimensions.
- Inside diameter and cross-section, with units
- Or groove diameter, groove width and the diameter it seals against
- Size code, if known (for example an AS568 dash number)
- Material and hardness, if known
Gaskets
Flange gaskets are identified by pipe size, pressure class and flange face. Equipment gaskets are usually cut to a drawing or traced from the old gasket or the mating surface; include thickness and bolt-hole positions.
Shaft and lip seals
- Shaft diameter, housing bore and seal width
- Numbers moulded or printed on the seal face
- Whether it has a spring, a dust lip or a metal or rubber outer case
Service conditions
Seal material must suit the fluid, temperature, pressure and whether the seal is static or moving. Include these so material options can be checked, and state any food-contact or other documentation required.
