Bearings
The number on a bearing ring or seal describes its type and size, and suffixes describe seals, shields, clearance and other features. Copy every character. If the marking is gone, measure the bore, outside diameter and width; many common ball bearings are metric.
- Full marking, including suffixes such as 2RS, ZZ or C3
- Bore, outside diameter and width if unmarked
- For mounted units: housing type, bolt spacing and shaft size
- Speed, load, temperature and contamination conditions
V-belts and synchronous belts
The belt code printed on the back identifies its section and length. Classical and narrow V-belts can share a top width but do not fit the same pulley grooves, so do not choose by width alone. If the code has worn off, measure the top width and the length, and count the belts on the drive.
- Code printed on the belt
- Top width and length, if unmarked
- For synchronous belts: tooth pitch, number of teeth and width
- The pulley or sheave markings, if visible
