Look for markings first
Part numbers are often printed, stamped or moulded somewhere other than the obvious face: on the edge of a bearing ring, along a hose, on the side of a belt, under a label, or on the equipment's parts list. A manual or previous purchase order may also list it.
Photograph it well
- Several angles, including both ends or connections
- A ruler or tape measure in the frame for scale
- Any markings, close up and in focus
- The part installed, showing how it fits the equipment
- The equipment nameplate with make, model and serial number
Measure what matters
Measure with a caliper where possible and state the units. Measure an unused or undamaged area, because wear, swelling and compression change dimensions. Where a part fits into something, the mating dimensions, such as a shaft, bore or groove, are often more reliable than the worn part itself.
Expect a review step
When a part is identified from photos and measurements, we confirm the match with you before quoting. Where the original is no longer available, possible alternatives are sent to you for review against your specification; compatibility is not assumed from appearance alone.
